[Gmecm] High CR TBI

[Programmer]

Just the single 670 unit (no injectors or pod of course), Tom. We used the 8 
injector Edelbrock system...
No added injector drivers, nothing wierd...the rest was just some careful 
tuning.

Lyndon


----- Original Message ----- 
From: "Tom Butcher" <di_dallas at yahoo.com>
To: <gmecm at diy-efi.org>
Sent: Friday, August 04, 2006 9:20 AM
Subject: Re: [Gmecm] High CR TBI


> Lyndon, what is the induction setup like?  Are you running two of the 
> Holley 4BBL TBI's or something else.  I ran a similar setup on a 500HP 383 
> stroker using a single 900 cfm Holley 4BBL TBI on a 16197427 PCM.  I built 
> quad P/H injector driver box to go between the TBI and PCM.  No reason you 
> could'nt use two boxes and run two 4BBL TBI's.  HotRod never gives credit 
> to the people who push the factory EFI to the limits.  It does'nt sell 
> their advertisers parts.
>
>  Tom
>
> Programmer <lwester at lincsat.com> wrote:
>  Just a heads up for you guys...
>
> Built a 12.5CR to 1 engine for a client, running this rig on a '7747 with 
> 8
> injectors in a 1990 pickup truck (daily driver). Funny thing is that the
> client contacted "HotRod" magazine and got laughed at...they said it can't
> be done.
>
> Anyway...he's presently blowing away LS1 Camaros with this combo at the
> track...and everyone is looking for the supercharger or the Nitrous.
>
> Best part is that he's also getting 26 MPG !
>
> Lyndon ; )
> Westers Garage
> 1-888-937-8371
> 403-377-CARS
>
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
> Main WWW page: http://www.diy-efi.org/gmecm
>
>
>
> ---------------------------------
> How low will we go? Check out Yahoo! Messenger's low  PC-to-Phone call 
> rates.
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
> Main WWW page: http://www.diy-efi.org/gmecm