[Gmecm] Heated O2 Current Draw

[Joe Vitek]

The resistance of the heater element changes with temperature. A meter will not give you
an accurate reading...

> -----Original Message-----
> From: gmecm-bounces at diy-efi.org [mailto:gmecm-bounces at diy-efi.org] On Behalf Of
> Programmer
> Sent: Tuesday, March 07, 2006 1:38 PM
> To: gmecm at diy-efi.org
> Subject: Re: [Gmecm] Heated O2 Current Draw
> 
> Ohms law E=IxR ...do the math. Measure the resistance of the heater
> circuit...
> It's a 12-14.5 volt system
> Doesn't take a big draw...
> 
> Lyndon.
> 
> ----- Original Message -----
> From: "Mike Poore" <mp at flowersbyvalerie.com>
> To: <gmecm at diy-efi.org>
> Sent: Tuesday, March 07, 2006 9:23 AM
> Subject: [Gmecm] Heated O2 Current Draw
> 
> 
> > Does anyone know the current draw for the heater circuit on a heated O2
> > sensor?
> >
> > I need to convert to a heated sensor.
> >
> > Mike