[Gmecm] Saturated/P&H injection

[Robin Handley]

> Interesting question.  The 727 can definitely operate high impedance
> injectors without trouble.  That's what it's used with in OEM
> applications.  If you look at the 7730 <-> 7727 equivalency chart on
> Ludis' page you'll see the connection for "Injector A Sense" on pin D5.
>   This sense line is used with low impedance injectors in P & H mode.
> The P & H circuit may be calibrated to operate only (2) 2.0 Ohm
> injectors.  You might want to check into this a little further.

Thanks again. Relieved to hear that my stock of scrap high impedance
injectors can be connected straight up! :-) I also think that, if I end up
using bike TBs with built in injectors, they are high impedance as well.

Robin