[Gmecm] RE: '727 mounting

[Robin Handley]

Having looked more closely, I spotted the cork block that's stuck to the 
underside of the MEMCAL trap door. I'm going to try and glue a bit of cork 
mat onto this, as the block isn't currently reaching the MEMCAL board...

Robin

----- Original Message ----- 
From: "Robin Handley" <Robin at FuryWorld.fsnet.co.uk>
To: <gmecm at diy-efi.org>
Sent: 15 April 2007 20:42
Subject: Re: [Gmecm] RE: '727 mounting


> Well, I completed my sill modifications, and mounted the '727 vertically. 
> Light the blue touchpaper and 200 yards down the road the fan comes on. 
> Cause: one side of the MEMCAL has fallen out so the ECM has gone into fail 
> safe mode. This happened more than once. I guess the MEMCAL retaining 
> clips just aren't up to my rock hard suspension and the poor road surfaces 
> around here. Maybe they would have been, when new.
>
> So, if I'm going to keep the ECM in its current position, I think I'll 
> have to cable tie the MEMCAL in place somehow! Unless there's a better 
> way...?
>
> BR,
>
> Robin
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
> Main WWW page: http://www.diy-efi.org/gmecm
>