<!DOCTYPE HTML PUBLIC "-//W3C//DTD W3 HTML//EN">
<HTML>
<HEAD>
<META content=text/html;charset=iso-8859-1 http-equiv=Content-Type><!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<META content='"MSHTML 4.71.1712.3"' name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT color=#000000 size=2>You'd need to check the timing tables and
compare against an original to see exactly "what" they enhanced. I'd
reconnect the EST circuit--without it, you're gonna grenade your engine.
</FONT></DIV>
<DIV><FONT color=#000000 size=2></FONT><FONT size=2>Once you get a cold air
package for your setup, it'll probably take care of the ping--but you'd better
get that EST hooked up again. I don't think the factory recommends disconnecting
it <g>...</FONT></DIV>
<DIV><FONT size=2></FONT> </DIV>
<DIV><FONT size=2>Lyndon.</FONT></DIV>
<DIV><FONT size=2></FONT><FONT face=Arial size=2><B>-----Original
Message-----</B><BR><B>From: </B>Jeff Flanary <<A
href="mailto:jefff@mounet.com">jefff@mounet.com</A>><BR><B>To: </B><A
href="mailto:gmecm@diy-efi.org">gmecm@diy-efi.org</A> <<A
href="mailto:gmecm@diy-efi.org">gmecm@diy-efi.org</A>><BR><B>Date: </B>April
7, 2000 6:24 AM<BR><B>Subject: </B>Pocket Programmer<BR><BR> </DIV>
<BLOCKQUOTE
style="BORDER-LEFT: #000000 solid 2px; MARGIN-LEFT: 5px; PADDING-LEFT: 5px"></FONT>
<DIV><FONT size=2>Hello All, I am new to the list, and so far, the extent of
my knowlege is just knowing how to change to different ECM's and factory and
aftermarket proms. I am just getting started in the programming stuff
and so far, it is very interesting. I just ordered one of the pocket
programmers from the transtronics website. It seemed like a good
programmer for the money. I am running a 1227747 in my S10 Blazer with
a TBI 305. I am interested in modifying my chip for best performance,
however, am going to go about this very slowly, because i don't know much
yet and don't want to smoke anything (engine). One question i have is
that i seem to have excessive detonation unless i run the 93 octane gas, and
even with the 93 octane, i still have a little. I am running a
hypertech stage III, and realize that it advances the timing more, also, i
have an open air cleaner which means that i am getting hot air off the
engine. I hope to have a good flowing breather w/ducting to the
outside soon. The chip i am running is actually for a TBI 350.
Does the ECM advance the timing more than stock under all driving conditions
with the hypertech chip, or just under WOT? Just a note, i am also
running an ACCEL replacement ign. set to 0 deg. with the EST
disconnected. This is what the factory recommends for my engine.
Any thoughts? Thanks and sorry this was so long.
Jeff</FONT></DIV></BLOCKQUOTE></BODY></HTML>