[Wbo2] Using the Bosch WB sensor with L1H1 circuit board

[Peter Gargano]

Wayne Macdonald wrote:
> Hi.
> I have one of the first DIY-WB circuit boards that was designed for the 
> L1H1 wide band sensor.
> Can I adapt this circuit board to use the cheaper Bosch wide band 
> sensors like the one found on the VW?

Wayne,

As much as I hate plugging our own product, as you are a fellow Aussi, 
I'll simply mention we do a DIY controller for the LSU sensor (in fact 
two DIY controllers, one with an inbuilt display). Our design is 
fairly mature and we have sold thousands as DIY kits. We also sell 
them pre-built. We also offer a fix-it service if you have trouble 
getting your unit to go (they are out of necessity complex pieces of 
equipment if they are to perform well).

As other will mention, there are a few people now who make low cost 
controllers for wideband sensors. Many are junk, and a few are 
reasonably good. We believe our DIY unit, when built, tested and 
calibrated as we describe, are as good as the Motec and Autronic units 
you'll pay up to AU$2,000 for. I'd say our unit is better, but that 
would be a bit OTT.


Peter Gargano
--
Tech Edge Pty. Ltd.    http://techedge.com.au     http://WBo2.com
ph : (02) 6251 5519    Int'l : +612 6251 5519     Fax : +612 6251 0558
Street addr : 37 Jalanga Cres.,  Aranda,  ACT 2614, Australia
Postal addr : PO Box 288, Jamison Centre, ACT 2614






te.