Dale's 68332

John S Gwynne jsg
Tue Nov 8 15:29:36 GMT 1994


--------

   In message <9411080221.AA10587 at coulomb.eng.ohio-state.edu> , you write:
 
| I'm just laying out a PC board for a 68332-based EFI computer. My application
| has four injector drivers on it, although it's going onto a 3-cylinder.
| It also has TTL level outputs for four ignition coils, which allows it
| to be used for any engine from a one-cylinder all the way up to a V8.
| True SEFI is available for 1-4 cylinder engines, though. 5-cylinders are
| a bit awkward, as well.
| 
| After I get a prototype PC board made up and tested, I wouldn't mind
| building up several of such boards... this will happen sometime in
| January or February. If there's interest, anyways.

Sounds good... I look forward to see what you come-up with.
Is this an "open" design where you will share both the
board schematics and software source code?

                                       John S Gwynne
                                          Gwynne.1 at osu.edu
_______________________________________________________________________________
               T h e   O h i o - S t a t e   U n i v e r s i t y
    ElectroScience Laboratory, 1320 Kinnear Road, Columbus, Ohio 43212, USA
                Telephone: (614) 292-7981 * Fax: (614) 292-7292
-------------------------------------------------------------------------------



More information about the Diy_efi mailing list