FW: Re: Knock sensor using HIP9010

[john carroll]

Everyone,

I promise that I will get som postings giong in the very near 
future.  A couple of projects are finished and very soon, "working 
on taxes" will cease to be a valid excuse 

john carroll  jac at wave.sheridan.wy.us


On Tue, 09 Apr 1996 15:48:12 EDT  Bruce Bowling wrote:
>X-Hpvue$Revision: 1.8 $
>Mime-Version: 1.0
>Content-Type: Message/rfc822
>X-Vue-Mime-Level: 4
>X-Mailer: Elm [revision: 109.14]
>Sender: owner-diy_efi at coulomb.eng.ohio-state.edu
>Precedence: bulk
>Reply-To: diy_efi at coulomb.eng.ohio-state.edu
>
>~ 
>~ I am designing a knock monitor around the HIP9010 chip. The data 
sheet
>~ only gives a "minimum" circuit. Has anyone actually used this 
component
>~ in a real application? I need to know two things:
>~ 
>~ 1. Is there any additional protection or biasing components 
needed for
>~    the inputs?
>~ 
>~ 2. What sort of settings are best for the programmable filters 
in this
>~    device?
>~ 
>~ Thanks for any assistance,
>~ 
>~ Jim Sturcbecher
>~ jsturs at bart.nl
>~ 
>~ 
>
>I am quite interested in your results (as is everyone else) - keep us posted.
>
>If I recall, there was someone on this list who used the HIP9010 chip on an
>airplane engine.  They were going to post more info, but I never saw it.
>
>- Bruce
>
>--
>-----------------------------------------------------
><<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>-----------------------------------------------------
>               Bruce A. Bowling
>  Staff Scientist - Instrumentation and Controls
> The Continuous Electron Beam Accelerator Facility
>    12000 Jefferson Ave - Newport News, VA 23602
>                 (804) 249-7240
>                bowling at cebaf.gov  
>        http://devserve.cebaf.gov/~bowling
>-----------------------------------------------------
><<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>-----------------------------------------------------
>

-----------------------------------------------
jac at wave.sheridan.wy.us
john carroll