MAP

[Clare Snyder]

>Maybe I did misunderstand what you're after.
>
>The GM sensors are active, not passive as a pot.
>
>Maybe if you describe what you're trying to do someone can 
>answer better then I have.
>
>Fred
>
>At 03:42 PM 8/8/97 GMT, you wrote:
>>>
>>>Try a GM one.
>>>3 pins: 5v, gnd, out
>>>the 1 and 2bar units seem to be pretty linear too.
>>>
>>>I think this is what you're after.
>>>
>>>Fred
>>>
>>>At 01:58 AM 8/8/97 GMT, you wrote:
>>>>
>>>>I've asked the question before and have not recieved an answer.
>>>>
>>>>Anyone out there know what MAP sensor, if any, outputs as a straight voltage
>>>>devider, resistor type device? I am looking for something that is basically
>>>>a pressure controlled rheostat.
>>>>Any ideas?
>>>>
>>Pinouts anyone? How about resistance specs?
>>
>>Thanks
>>
>>
>>
>
>
I've got one, off of the vehicle, that I want to test and see exactly what
it does and iff I can use it on a project


(---++----)
( O  O  O )
(---------)

 1   2  3  

Which pin is +5V,  Which is Ground, and which (obviously the only one left
<G> is the signal? Facing the connector on the MAP, connector up and vac
line to left.