EPROM Compatibility Question

[Sandy]

Thanks Terry, But the 571000AD's program and check out on the programmer
A-O-K. I have a dataman S4 that supports the chip directly (128kx8) but
they just don't seem to work on the 332 board. I copied the EPROM that has
the motorola CPU32Bug that was sent and it will not work. The speed is
within range, so either the eproms are really out of spec, or they are just
different. I really have no idea if the 571000's are the same. I got them
at fry's, and they are about one step above the shack (as far as I am
concerned) they were marked in the plastic pack as 27c010's but that may be
BS!

Sandy

At 09:39 AM 8/10/97 -0700, you wrote:
>Sandy wrote:
>> 
>> HELP - I have a EPROM question, and don't have the data books. Here's the
>> problem. I'm trying to get this 68332 Board up, and the EPROM's that I
>> purchased are Toshiba  TC571000AD's The board uses a 27C010A. Are these
>> compatible. My programmer can program them just fine, but they don't seem
>> to be working. They do check out as programed from the programmer, and the
>> data in them looks good.
>> 
>> Help!
>> 
>> Sandy
>
>Try a verify of the device data against the programmer several different
>ways. Use the device limits against the entire programmer ram. I suspect
>that the programmer loads at 0000h and if you don't set the device
[snip]