Wiring Pinout
steve ravet
steve at imes.com
Wed Dec 3 00:26:58 GMT 1997
Christopher J. Bruno wrote:
> wiring harness - complete; I only had to cut one blue wire going UNDER
> right side of engine (not sure what it was) and the
charcoal cannister purge? On the TBI 350 I put into my Blazer those
wires were routed under the oil pan. Also, I seem to remember
alternator wires going under there. I specifically remember a pair of
wires (red and blue) that went under the pan, but I can't recall exactly
what they were for, other than I didn't need them but left them in place
because I couldn't extract them from the harness. That helps a lot,
huh?
> What I was wondering from you guys (and gals) is does anybody have the
> wiring pinout from the computer as well as the wiring diagram for the
> harness. I imagine that the wires that are going up under the dash
> are for the VSS, check engine light, ALDL connector but I'm not sure
> what else. I also know that there were a couple of connectors on the
> AIR injection valves which I don't plan on using but I'd like to make
> sure. If anybody has this info and can send it to me I would appreciate
> it very much. THANKS!!!
Chris, you really need to buy the Chevy service manual for that IROC.
It'll save you a lot of time and headaches. I spent about 40 hours on
the wiring to put a 350 TBI motor into my S-10, with the factory manual
for the donor engine and a Chiltons for the truck. It would have been
easier if I had the factory manual for both.
--steve
More information about the Diy_efi
mailing list