IAC
peter paul fenske
pfenske at direct.ca
Tue Dec 9 17:01:05 GMT 1997
Hi
Best bet is to use a GM TB on the ford intake. I sized a
tpi TB to a ford one and they are pretty close. I mean the
truck double TB.. A 1/2" alum plate should do it.
Otherwise you have to graft on the IAC. I think the ford
is a pwm setup similiar to a polorator on a satellite feed.
cya:pete
Might be a DC motor too.
Not sure
At 03:42 PM 12/8/97 EST, you wrote:
>I have seen several postings of projects mentioned where the builder is using
>a GM ecm for engine management on a ford crate engine. Sounds like a good
>idea, just one question. How do you address the IAC motor? The ford has two
>circuit motor and the GM has a four circuit motor? Can the GM IAC motor be
>attached to the ford intake manifold?
>
>
More information about the Diy_efi
mailing list