FW: Re[4]: Hydrualic pressure to HP formula

[john_carroll]

The assembly you are writing about is listed at $300 in the catalog I have at the office.  They are in Lincoln Nebraska



---------------Original Message---------------

>
>----------
>From: 	Terry Sare
>Sent: 	Monday, June 16, 1997 12:54:00 PM
>To: 	diy_efi at coulomb.eng.ohio-state.edu;
>owner-diy_efi-outgoing at coulomb.eng.ohio-state.edu
>Subject: 	Re[4]: Hydrualic pressure to HP formula
>Auto forwarded by a Rule
>
     Catalog is at home but will bring it in and post tomorrow. No email
or 
     web page available last time I checked.
     
     Terry 


______________________________ Reply Separator
_________________________________
Subject: Re: Re[2]: Hydrualic pressure to HP formula
Author:  owner-diy_efi-outgoing at coulomb.eng.ohio-state.edu at dell_unix
Date:    6/16/97 1:46 PM


Would you have an address, phone number, or email address for "Surplus
Center"
     
you could post?
     
To: diy_efi <diy_efi at coulomb.eng.ohio-state.edu> @ INTERNET,
owner-diy_efi-outgo
     
ing
<owner-diy_efi-outgoing at coulomb.eng.ohio-state.edu> @ INTERNET 
cc:
From: Terry Sare <Terry_Sare at dell.com> @ INTERNET 
Date: 06/16/97 11:39:14 AM
Subject: Re[2]: Hydrualic pressure to HP formula
     
     Company called "Surplus Center" had a complete small axle assembly 
     with two motors and a pump built into it. They only wanted $700 for
     it.:-( Would mount up neatly to go kart. They also had surplus 
     hydraulic motors, pumps, etc.
     
     
     Terry


----------End of Original Message----------

-------------------------------------
jac at wavecom.net
 06/16/97 16:53:34