4-cyl HEI in GM Autos?
amcknig at creighteld.k12.az.us
amcknig at creighteld.k12.az.us
Fri Nov 28 16:05:38 GMT 1997
Clare
I guess that works OK but the 4cyl cap is a nice clean installation.
Standard part # DR-448 or Blue Streak part DR-448X.
Just make sure that the rotor and capped are "phased" properly.
I have several caps with observation holes cut in them so I can
observe the fire between the rotor and the cap at different degrees
of advancement. One way to set this if you don't run vacuum advance,
is to cut off the diaghram , braze the actuating rod to the mounting
plate at the place where you have the proper phasing. You can use
old vacuum advances for this. Get several so if you don't get the
desiored results, make another.
Bob McKnight
Phx AZ
More information about the Diy_efi
mailing list