Urgent, Need help with a DFI harness
Andris Skulte
askulte at emerald.tufts.edu
Thu Apr 30 14:57:14 GMT 1998
Ed wrote:
> 2) There's supposed to be a 3-pin (color black) plug for the TPS.
> Again, there's no plug..another fine modification by JG. What color
> wires go to the TPS, and what is each wire's purpose?
TPS A Dk green (TPS return) goes to D1 on the DFI connector
TPS B lt blue (TPS signal) goes to C1
TPS C yellow (+5V ref) goes to D5
> the RPM trigger (usually used for nitrous). Any way I can tell through
> physical description of the wiring?
All the DFI ECM's have this capability. I think it's off the global
variables menu... You either ground or power pin B9 (nitrous enable) and
then the output is B11 (nitrous solenoid)
> We don't have the calmap software
> (dyno place does), but I'd like to know before we finalize the wiring.
If the software isn't copyrighted, I can email a copy, since you need
their little black box anyways. The $200 for CALMAP and the cable is
worth it if you plan on doing some tuning. HTH
Andris
--
*********Skulte Performance Designs---WWW.SKULTE.COM**********
Your third and fourth generation f-body specialists
******89 IROC M5 305TPI---13.5 at 104.1--320 hp/475 ft-lbs*******
More information about the Diy_efi
mailing list