Injector Driver Module

[Gregory A. Parmer]

On Thu, 6 Aug 1998, Jose  Rodriguez wrote:
>   I am designing an injector driver module.

If you haven't do so already, you should compare
your design to the EFI332 one at
http://efi332.eng.ohio-state.edu/efi332/hardware.html


>   Injector coil resistance: 1.5 ohms (it could also be 2.3 ohms)
<snip...>
>   If all 8 injectors could be on 85% of the time, then the maximum 
<snip...>

A few more quick thoughts. GENE already pointed out that for a 4cycle
engine you're talking about half of 85%. Also, I think most
OEM port injectors have a higher resistance (15+ ohms?).
This makes your power consumption figures look **much** better.
Also, mounting your module in the car interior as most OEMs
do helps your underhood heat problem.

When's the prototype scheduled?   :)
-greg