Wide range lambda sensor

[Bruce Plecan]

-----Original Message-----
From: Chad Clendening, <clendenc at execpc.com>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Saturday, August 29, 1998 5:03 PM
Subject: Re: Wide range lambda sensor


>I compiled about 7 good pages from previous posts about EGOR with pinouts
>and the current levels I can post these if you havn't found the info yet.

I would really like a copy of that.  My efforts at doing that aren't going
to well.
TIA
Bruce          nacelp at bright.net
>
>I also spent a while on the web and found ONE website which shows an UEGO
>sensor and is specific to the NTK 5 wire version.  This has a very general
>schematic - using one op amp to set the current level in the oxygen pump.
>This referances SAE paper # 920234, from 1992.  This number has been
>mentioned on the EFI list previously, has anyone seen it?
>
>Chad
>
>
>
>