Weber - Marelli ?

[Tom Sharpe]

I added the Edelbrock to it   most are the same>

Kapocs Attila wrote:

> Axel,
>
> Here is what I promised:
>
> 35 pin connector
> Lancia Dedra 1995 turbo (Delta has the same ECU and engine)
>
> 1-ground-Y
> 2-lambda-signal-Y
> 3-ground for crankshaft position sensor-NU
> 4-signal from cranksaft position sensor (4 signal each revolution 90
> degree per one)-NU
> 5-ground for phase (cylinder select) sensor-Y
> 6-ground for diagnostic connector-NU
> 7-?-NU
> 8-for diagnostic connector-FOR PROGRAMMER UNIT W/ LCD AND KEYPAD
> 9-CO potentiometer (if present)-NU
> 10- nc (not connected)-DIODE PROT

> 11-signal ground -NU

> 12-Check Engine light-NU

> 13-nc
> 14-nc
> 15-signal from MAP sensor-Y
> 16-BPC (Boost Pressure Control) Valve control-NU
> 17-signal from throttle potentiometer-Y
> 18-control for 4th cylinder injector-Y2
> 19-ground-Y
> 20- positiv voltage from main relay (present when ignition is on)-Y
> 21-Air Conditoner-NU
> 22-Knock sensor signal-NU
> 23-phase (cyl.identification signal)-(DISTIBUTOR SENSOR-8 TEETH-ONE
> SMALL)
> Two signal each two revolutions, assimetric.
>
>             I_ this is the pattern for the sensor like an "L"
>
>
> 24-ground for ignition module pin 3-Y
> 25-control for ignition module pin 6-Y
> 26-nc-Y
> 27-diagnostic connector-Y
> 28-control for fuel pump relay-Y
> 29- signal from Engine coolant temperature sensor-Y
> 30-+5V for throttle position sensor and for MAP sensor-AND IGN AMP
> 31-Signal from Air Temperature Sensor-Y
> 32-Control for 2nd cylinder Injector-Y4
> 33-Control 3rd cylinder Injector-Y3
> 34-Control for IAC Valve-Y
> 35-Control for 1st cylinder Injector-Y
>
> I hope this will help.
>
>     Regards
>                                     Attila Kapocs  AND TOM