Source for efi harness componants

[mrvette]

To me, It is the only way to go, cost wise,  unless you be VERY busy, in which
case you shouldn't be doing the project anyway.:-)))

I would go to a junkyard and clip off the harness ends with as much pigtail as
you can get....under the hood as well as at computer....

and splice/solder/tape wires....pull extra from old harnesses...get your
colors/lengths there....I would not waste time trying for a complete
harness....the lengths are all wrong anyway....GENE

JE Messler wrote:
> 
> If one wanted to construct new efi harness's from scratch, who would be
> a good source for ecu connectors, weather tight injector and sensor
> connectors, special wire crimpers, etc..
> Jim Messler