VSSS
TBK
terryk at foothill.net
Wed Mar 4 03:42:04 GMT 1998
Be aware there are 8 pole generators used on after market cruise controls. I
have one. Hit the speed limter at 62 MPH.
A good source for 4 poles are 82-87 Olds Ciera's and Buick Century's with
after-market cruise. These are 4 pole. They are located in the engine
compartment in the center just below the wipers. The Ciera and Century have
a two piece speedo cable (when not equiped with factory cruise) to allow the
VSS to be installed. I grab them whenever I see them.
TK
-----Original Message-----
From: Peter Fenske <ffnsp955 at bcit.bc.ca>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Tuesday, March 03, 1998 1:20 PM
Subject: Re: VSSS
Well you could always put 4 magnets on a driveshaft and
use a magnetic pu..
The JTR setup is good and you can get either the four or two pole
FYI taxicabs use a similiar rig. So wreck I mean recyling yards
later:peter
> I recall reading that Mopar had something like this in their early EFI
cars
> from the factory... Could try to dig up that book if ya like... KV.
>
> ________________________________________________
> Kevin Vannorsdel IBM Arm Electronics Development
> 408-256-6492 Tie 276-6492 kv at us.ibm.com
>
>
>
>
> owner-diy_efi at efi332.eng.ohio-state.edu on 03/03/98 10:04:51 AM
> Please respond to diy_efi at efi332.eng.ohio-state.edu @ internet
> To: DIY_EFI at efi332.eng.ohio-state.edu @ internet
> cc:
> Subject: VSS
>
>
> Hello,
> I was curious what some people have done
> to add VSS output to older cars that didn't have
> them initially. JTR sells a VSS 'box' that attaches
> inline with the speedo cable and will output the
> standard 2000 pulse per mile required for the 85-89
> GM computers, but it is $70. I would like to keep
> my stock speedometer if possible, if for nothing else,
> just so that my dashboard matches. What are other
> people's expereience in this area?
>
> --
> Christopher Bruno
> Teradyne
> 321 Harrison Ave. MS/H53
> Boston, MA 02118
> 617.422.2040 Office
> 617.368.7062 Fax
> bruno at icd.teradyne.com
>
>
>
>
>
More information about the Diy_efi
mailing list