Haltech's

[Lino Verna]

I'll put dibbs on an F3 w/harness  and a trim pot.
Preferably a 4 cylinder harness.

Also,  it may be time to discuss methods of payment...

Just lemme know.

lino



>Hi again Everyone,
>   I talked to Dell at Haltech(972-831-9800) he stated all the f3's will
>handle up to an 8 cyl engine and the tach signal is the only differences
>between the ones that are here....there is also an E5 but couldn't
>identify if it had the timing map also....To state this correctly there
>are 6 F3's 2 F7's and an E5....I will sell the F3's for $350. w/harness
>the F7's for $350. w/harness and the E5 for $450. w/Harness...The two
>F3's w/o/harness for $200. each...Dell said he has the pinouts to give
>out so you can make your own harness or buy one from him...He also
>stated that worst case was under $100. for any mods required to make
>these units work for a specific application...The mixture control pots
>give you the opportunity to alter the fuel map +\- 15% from the
>dash,$25.00 each,,All units are laptop real-time programable....I know
>these prices are cheap but it's finally my turn to help the DIY for
>once.....Once I buy these I'll be stuck with them so make sure it's what
>you want before I make this purchase,,I am not very familiar with these
>units, so a quick call to Dell at Haltech would be good
>planning...Thanks,
>-Carl Summers
>
>
>Carl Summers wrote:
>> 
>> There are a totol of 9 Haltech's, 4 mixture control pot's and only two
>> don't have harness's...does anyone know the phone # for Haltech so I can
>> identify exactly what is here?????Thanks,
>> -Carl Summers
>