GM 4 Cylinder Engines
Bruce Plecan
nacelp at bright.net
Tue Nov 10 23:40:14 GMT 1998
-----Original Message-----
From: Pete Datcuk <pdatcuk at snip.net>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Tuesday, November 10, 1998 6:29 PM
Subject: RE: GM 4 Cylinder Engines
> The Quad-4 in its base version was 150hp, then 160hp, and HO version was
>180. Displacement was 2.4l. 16v DOHC. They were redesigned '95/'96 area,
>added balance shafts, stroked and debored it, cut displacement to 2.3l and
>derated them back down to 150hp. Also cut the rev limit by a few hundred
>RPM.
>
>Pete Datcuk
>Mechanical Engineer
>Sewell, NJ
>'87 Fiero, some day to be Northstar'ed :-)
>Quite a few credits away from that cone shaped hat....
Tis nice to have a goal in life, and setting low standards help
quarantee success.
Have you started gathering electronics toward the Northstar?.
Or any one clear about the crank/cam sensors, electronic
modules?.
Cheers
Bruce Credits to loan for Cone Shaped Hat Wanna bes..
>
>> -----Original Message-----
>> From: owner-diy_efi at efi332.eng.ohio-state.edu
>> [mailto:owner-diy_efi at efi332.eng.ohio-state.edu]On Behalf Of
>> martin at mgass.demon.co.uk
>> Sent: Sunday, November 08, 1998 3:25 PM
>> To: diy_efi at efi332.eng.ohio-state.edu
>> Subject: GM 4 Cylinder Engines
>>
>>
>> Anybody know if GM does a 16V DOHC
>> 4 Cylinder Engine with EFI of less
>> than 2500cc in the US for Vehicles
>> made after 1994 ?
>>
>> regards,
>>
>> Martin
>> ----------------------------------------------------------
>> martin at mgass.demon.co.uk
>> ----------------------------------------------------------
>>
>
More information about the Diy_efi
mailing list