GM MAP Sensor Identification, for the boneyard surfers

[Bruce Plecan]

-----Original Message-----
From: ECMnut at aol.com <ECMnut at aol.com>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Wednesday, November 18, 1998 10:25 AM
Subject: GM MAP Sensor Identification, for the boneyard surfers


>I obviously don't want to get any of my real work done today..  8-)
> When I first ordered a MAP sensor from the GM dealer, 
> I thiugh I recieved the wrong part.  Just a little plastic thing with
> wires & a vacuumm line..
>
>Because someone asked, I captured & cleaned up a picture
>of a GM 3 bar sensor..  Aside from a number stamped into the 
>top, they (1,2 & 3bar) all look the same...I don't know the
>number on the 1 bar, but the 2 & 3 bar numbers are there.
>Check out my pic at:

Should of had Buford holding it,  I didn't know about the number deal.
Mine looks like an 834(?), can someone double check?.
Bruce

>       http://www.enzoco.com/mike/sensors.gif
>HTH
>Mike V
>