MAP Sensor
Tom Parker
tparker at nznet.gen.nz
Thu Nov 19 07:55:57 GMT 1998
Bruce Plecan <nacelp at bright.net> wrote:
<TPS sensor>
>They don't read as you would expect with an ohm meter. However,
>I use a Pot as a voltage divider on the bench ecms no problem
>(yet?)...
Sounds good. If I make my own TPS sensor from a pot in this configuration,
then I won't have any trouble getting ths signal into the computer, but what
about the map sensor.
What does the output from a MAP sesnor look like? I understand it is a voltage
between 0 and 5v, but how do you wire it up? Assuming I have a MAP sensor of
unknown origin, how do I go about indentifying the wires?
With three wires, and the probable fact that it is a voltage divider much like
a pot, I suppose I could work it out with an ohm meter.
--
Tom Parker - tparker at nznet.gen.nz
- http://www.geocities.com/MotorCity/Track/8381/
More information about the Diy_efi
mailing list