BBC AKSN

[David A. Cooley]

At 05:07 PM 10/24/98 -0400, you wrote:
>I just got aksn.bin off of the FTP site and I thought that I would play
>around with it a little.. First of all its off of a 88 4.3 V6 5 spd..
>Well when I run it, it starts just fine, idles real smooth but as soon
>as it goes into closed loop it stalls,  Well I increased the idle in the
>chip to 900 across the board now it will idle but it oscillates between
>1100 to 700.  Looking at the injector patterns, the injectors are
>turning off completely, then the rpm drops they start pulsing again and
>the rpm climbs to 1100 again and they stop completely again... This is
>the only chip that has caused this to happen.. Anybody have any ideas
>what is causing this?....  Thanks   Jason

What engine/vehicle did you put it in?
The IAC may be different and asking for more steps to make the same
adjustment yours can do in fewer steps...
Later,
Dave

===========================================================
           David Cooley N5XMT           Internet: N5XMT at bellsouth.net
     Packet: N5XMT at KQ4LO.#INT.NC.USA.NA   T.A.P.R. Member #7068
       I am Pentium of Borg...division is futile...you will be approximated.
===========================================================