EEC-IV Modifying

[FHPSTANG1 at aol.com]

In a message dated 4/11/99 3:25:55 PM Eastern Daylight Time, psd105 at psu.edu 
writes:

<< The whole basis for my project is to do it as cheaply as possible.  Most 
of the
 parts I'm using are stock Ford parts, that were modified by me for this
 project.  The turbos are even off of Ford production cars, purchased for $25 
ea
 in perfect working order!! >>

This sounds like my project. I have a 1979 Mustang, in which I will install a 
stock 5.0L HO motor, and use two T-03 turbos off of Turbo Coupes. I plan on 
running an '89 mustang 5.0 MAF EEC-IV EFI system.

For quite some time now I have been looking at how to add the low imp. 
drivers out of a 2.3L computer, into the 5.0 computer. I have disassembled 
BOTH computers, and the operation looks like it could be very simple. I have 
a few questions, and was also referred to the EEC Mailing list. However, I 
haven't had the chance to ask that list questions, and then wait around for 
the answers. But the EEC mailing list is the place to go!

John Miller
91 FHP Special Service
89/86 'stang & 85 Merkur 2.3L Turbo Hybrid
84 GT350 5.0 T-Top
79 Twin TURBO Project