GM '86 2.8 Fuel Injected prom re-programming/replacing

[Ludis Langens]

James P Hunt wrote:
> As I stated in a previous post, I have an '85 Fiero, that I am planning
> to turbocharge, but I failed to mention that the ECM, wiring, etc. is
> from an '86 Fiero. 
>
> I realized this after the last time I took my interior apart and noticed
> a late-model style ECM.

The 1226869 (85) and 1227170 (86-88) ECMs both have the same harness
connections.  Chips are not interchangeable between the two though.

> So now my question is as follows, does anyone know where I can find a
> prom file, or info on programming a replacement prom for the ECM,
> preferably to use in conjunction with a 2-bar MAP sensor.

You may be able to buy a chip all ready to go.  Contact Kevin Leslie at
Design One systems who sells the Miller/Woods turbo kit for the Fiero
V6.  I don't know if Kevin will sell just a chip.  The full bolt-on kit
(turbo, plumbing, chip, 2-bar MAP) sells for around $3K.  Sorry, I don't
have an address or phone number.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/