DIY_EFI Digest V4 #493

[neilaura at accessworldnet.com]

>How about this question... Does anybody know of a source of throttle plate
>assemblies for an individual throttle injection type system? Or, almost as
>good, plans/diagrams? I have access to a CNC milling machine on an "if
>you'll fix it" basis, and I bet I could fabricate the parts myself if I
>really needed to... but I'm no machinist and the mill has a blown servo
>card ($1500 to replace, or probably $1.50 to fix if I took the time to
>figure out what was wrong), so I would rather not go that route.
>
>- -Jon
>
It may be of no help Jon. But check out late 70's early 80's Kawasaki
KZ750/1100 motorcycles. They came with the option of fuel injection. The
system never worked right, and when something went wrong with the
electronics, with a replacement cost of one arm, one leg and your first
born, the FI was pulled off and replaced with a set of carbs.
The KZ1100 was an inline 4 motor with 4 individual injector/butterfly
bodies. It may be a starting point for ideas.

Neil