808 Request
Ken Kelly
kenkelly at lucent.com
Thu Feb 4 14:42:17 GMT 1999
Jon,
Where are you located. I'm in Northern NJ and have an Eprom
Burner & eraser. If you have the image you want installed &
the chip to install it in I can do it for you.
Ken
Jon Fedock wrote:
>
> Hello All,
> I have a request, hopefully someone here can help me out. I have 2
> vehicles that I have transplanted TPI into. One is a 305/t-5 and the other
> is a 350/700r. I have a bad MAF on the 305, and would like to use this as an
> excuse to change over to a MAP style setup to eliminate some of my plumbing
> nightmare. Since I am using the 165 ECM, I am thinking of using a 808
> calibration (ASBX ?). As I understand it, ASBX was for a 5.0L motor, so it
> should be pretty close? I can hadle the wiring differences. But not the
> Eprom. This is where it gets tricky. I don't have (or have access to) an
> EPROM burner. Would anyone on the list be willing to burn the required chip?
> I will pay for time, shipping, the chip itself, etc.
> Or, would I be better off to just go and get a 730 and a Memcal for a
> comparable Camaro/Firebird (More $$$)? My plan is to eventually put MAP on
> the other car also, but I know the calibration is probably too far off. One
> step at a time.
> Thanks for any input or correction,
> Jon Fedock
More information about the Diy_efi
mailing list