Plugs for flare fittings?
Don.F.Broadus at ucm.com
Don.F.Broadus at ucm.com
Fri Feb 5 20:16:51 GMT 1999
NPT is national pipe thread and is available at ACE hardware,Handy
Andy and any other type of hardware store.
They go for about $.14 each in steel the brass parts are a little
more. NPT is a standard thread and pitch so that's
all you will need to say to get the plugs, 1/4 NPT
> -----Original Message-----
> From: bearbvd at sni.net [SMTP:bearbvd at sni.net]
> Sent: Friday, February 05, 1999 1:38 PM
> To: diy_efi at efi332.eng.ohio-state.edu
> Subject: Re: Plugs for flare fittings?
>
>
> Any suggestions on where to find
> >something like that?
>
> What thread are the holes?? (Diameter & pitch)
>
> A few places told me that if they had
> >them, they'd only be in brass. If I can find brass ones, would they
> >work?
>
> Brass be fine.
>
> Regards, Greg
> >
> >thanks,
> >--steve
> >
> >
> >--
> >Steve Ravet
> >ARM, INC
> >steve.ravet at arm.com
> >www.arm.com
>
More information about the Diy_efi
mailing list