TH-400 help

[Bruce Plecan]

-----Original Message-----
From: Marc Piccioni <mpiccioni at attcanada.net>
To: 'diy_efi at efi332.eng.ohio-state.edu' <diy_efi at efi332.eng.ohio-state.edu>
Date: Wednesday, February 24, 1999 12:30 AM
Subject: RE: TH-400 help

Before deleting it I'd look at installing it.  I'd reseach if it's a 2000
ppm, or 4000 ppm
deal, and if so then just use a Jags That Run speedometer cable inline
device.
Coast down enleanment/IAC reset works off of VSS "ususally".  Your PCM may
be
all different from what I've seen so far..
Bruce

>2.  Does anyone see any problems with deleting the speedo sensor, since the
>speedometer on my car takes its reading from the differential, and I'll be
>using a manual transmission calibration with the PCM... (96 LT1)  I think
>the only thing that a manual cal uses the speedo for is idle speed, and I
>can do without that.  Error codes aren't a concern...
>Thanks a lot,
>Brock