Water Injection Thread [now U joints]

[Shannen Durphey]

diy_efi at efi332.eng.ohio-state.edu wrote:
> 
> Greg Hermann wrote:
> 
> > ... you could also dig up and use an old Mopar ball&trunnion
> > >joint, which will also handle more angularity than the saginaw or spicer,
> > >plus it is a plunge joint, so it handles the slipyoke problem, too.
> >
> > Is this the proper name for the things I have inside the (closed type)
> > steering knuckles of one of my Dana 70F steerable drive axles, which I have
> > always heard called (usually affectionately) "Chinese Puzzle Joints"??? Or
> > are they something else again??
> >
> > Regards, Greg
> 
> For the work-a-holics, just make a drive shaft using an old shaft, some 1/4
> plate steel, a lathe, welder, and an axle from a FWD GM midsize.
The real work-a-holics use a hacksaw.  And don't tell me I can't cut a
straight line with a hacksaw.
Shannen