749 calibration in a 730

ECMnut at aol.com ECMnut at aol.com
Sat Jan 9 15:47:37 GMT 1999


Bruce,
Sounds very cool..  
Are we talking about  730 turbo development program?
They sure are easier to locate than the Syclone 749..
Did you do this in a 256k EPROM?
Just curious
Mike V.

In a message dated 1/9/99 9:45:23 AM Eastern Standard Time, nacelp at bright.net
writes:

> Well, after finding some faulty hardware, I got the syclone calibration
>  to run in a 730 ecm.  Doing so moved some pinouts about, for TCC,
>  and VSS, but it is seen by diacom, and things look ok.  I haven't
>  attempted to make this a legal calibration, so I'm ignoring the
>  air management valves, and EGR for now, but all the engine stuff
>  looks to be running right, and TCC works.
>    I'll post a summary later today/tomorrow, but just had to babble/brag a
>  bit about it........
>  Bruce          When sharper Cone Shaped Hats are worn, it'll be done
>                      here first.........



More information about the Diy_efi mailing list