Heat sink compound
Randy
rbraun at enter.net
Sun Jan 10 19:45:50 GMT 1999
OK, so after reading this thread I got that most HSC are insulators
except the stuff that contains silver, Where do you get this stuff?,
So on the CS-130 alternators the neg side of the diode pack is
mounted to the case with HSC and has no screws to ground it. The
screws are all insulated. On my last rebuild I used T & B"copper
kote" on the ends where the positive bolt goes thru it and on the
other end where I added an 8-32 nut and bolt to hold it tight and
ground it. the middle I put standard HSC. Maybe the silver stuff
should be used on the whole thing? Looked like a major flaw in
the design to me, as I have fixed about four of these all with dead
neg side diodes.
Randy Braun
'77 C-10 pick-up, DFI-Tuned Port, 350
'82 Firebird, DFI, ZZ3
'91 GTA, Stock
More information about the Diy_efi
mailing list