Prowler V6

[Todd....!!]

Will do Peter,

However, reason I tried Sears was cuz I had about $12 of credit with em
from a trade in deal(Misplaced/Lost the receipt, they only give credit
when that happens)

Will try the Depot...

Thanks for the reference...

LATER!

Todd....!!

Peter D. Hipson wrote:
> 
> You've got it. Understanding is a wonderful thing, isn't it? BTW, I think
> Sears is out of the metric ones, try Home Depot's tool section (Husky).
> 
> At 09:39 AM 6/1/99 -0700, you wrote:
> >So, if I understand correctly we'll need a metric magnet in order to
> >tell whether our pistons are aluminum or not?
> >
> >Just checkin....
> >
> >LATER!
> >
> >Todd....
> >
> >C. Brooks wrote:
> >>
> >> You're TOO cruel, SnapOn doesn't carry metric magnets... But Craftsman does
> >> :)
> >>
> >> Charles Brooks
> >>
> >> -----Original Message-----
> >> From: Jim Davies <jimd at vcc.bc.ca>
> >> To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
> >> Date: Friday, May 28, 1999 7:37 PM
> >> Subject: Re: Prowler V6
> >>
> >> >
> >> >
> >> >On Fri, 28 May 1999, Todd....!! wrote:
> >> >
> >> >> Anybody in here ever ran FORGED steel pistons?  or do most of ya'll only
> >> >> run CAST iron pistons?
> >> >>
> >> >> Just wonderin what kinda answers I'll get from this....
> >> >>
> >> >> I run forged hypereutectic myself, but a magnet won't stick to ANY of
> >> >> em!
> >> >>
> >> >> Anyone know why?
> >> >>
> >> >You have to use a special magnet for these. Try SnapOn...
> >> >
> >> >
> >> >
> >
> >
> >
> >
> Thanks,
>         Peter Hipson (founder, NEHOG)
>         1995 White NA Hummer Wagon