730 program

[Mike Pilkenton]

Why would I need a V8 MEMCAL?  I'm running a 3.1L V6 motor.

Mike
-----Original Message-----
From: Peter Fenske <pfenske at bcit.bc.ca>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Tuesday, June 01, 1999 11:19 PM
Subject: Re: 730 program


>
>
>Hi Mike
>
>All the code on the main mpu is in the calibration pak.
>Make sure you get a calpak for a V8 application if you are gonna
>run a V8, V6 calpaks don't work
>
>About the only thing you gotta worry bout is vats and maybe the egr error
>bit
>
>None of the other stuff is required
>
>gl:peter
>
>
>    I have a 730 ecm variety from a 92 Camaro 3.1L V6.  Does this ECM have
>all the programming and tables located in the EEPROM (MEMCAL) or does it
>contain some of the base program in ROM somewhere else on the PCB?
>
>    I'm curious because I need to get it reprogrammed to remove the EGR,
AC,
>AIR, and VATS functions.
>
>