ProJection mods, was Re: New to list, have a question.

[cloud at peaches.ph.utexas.edu]

At 01:37 PM 3/9/99 -0600, you wrote:
>At 07:45 AM 3/8/99 -0600, you wrote:
>>
>snip
>> 1 . my setup, without the EGO feedback, goes very lean at the slightest
>>increase of the throttle from cruise. Best I can figure is the slight
>>opening of the throttle plate adds enough extra air to make it lean
>>but the tps voltage increase isn't adequate to be sensed as an increase
>>in fuel ????
>
>I saw this problem on a friends Bronco with the 2 Barrel ProJection.  But
>it was never a problem for me until I installed the closed loop kit.  I
>recently leaned out the adjustments and this problem has almost disapeared.
> Since the closed loop kit is no longer making the mixture a LOT leaner it
>does not interfere with the throttle responce as much.
>
>
>> 3 . are you aware that I have made a parts list for the 502 (or is
>>a 520 ??) and a PCB drawing for it ??  Someone has a web site for
>>the Holley ProJection (lemme look .....  yeah, check with
>>Andy <mpc at genevaonline.com>.  He had the stuff I did on that site. Dunno
>>if he still has it or not. If you want what I have on the ProJection,
>>holler and I'll send it to you
>
>No, I was not aware of that.  I would like to have any information you can
>supply, thanks.
>If you can find the address of that ProJection site I would like it also.
>
>snip
>
>>>I really like the throttle body part of the ProJection, but thats the only
>>>part I really want to keep.  I'm not all that happy with the controller.  I
>>>really want something that I can have more control over and that will
>>>accept input from more sources.
>>>
>>>Eric
>>
>>You are in the right place, IMO  ....  there's several who have
>>adapted the GM ECM to the ProJection TB.  "Bruce Plecan"
<nacelp at bright.net>,
>>who is on this list, is probably your best contact, IMO.
>>
>>
>>Tom Cloud <cloud at peaches.ph.utexas.edu>
>
>Again, I would love to have any information that anyone can give me on
>doing this type of conversion.
>
>
>
>Eric Comstock
>esc at firstnethou.com

Eric, I've just finished putting some ProJection info on my automotive
site

	http://www.austin.cc.tx.us/ESA/tc_auto.html

(see first link at top)

I, too, would like to "re"-find the site on the Holley ProJection ....
anyone know where it is ??  It was done by Andy Quaas <mpc at genevaonline.com>.
Don't have any web info though (musta lost it).



Tom Cloud <cloud at peaches.ph.utexas.edu>