FI fuel line

[Shannen Durphey]

I am using it on a TBI setup.  There are places where GM uses short
lengths of high pressure rubber line in PFI systems.  As long as it
can handle the pressure, and it's well routed, and not overly long,
should be ok.
Shannen

Mike Pilkenton wrote:
> 
> I'm getting ready to run my fuel line for my engine transplant project and
> need to change over the stock low pressure carb. lines to high pressure
> lines designed for fuel injection.  Was planning to get steel line and form
> fittings and all but my local speed shop now has high pressure rubber hose
> designed for FI systems.  It apparently has a high strength braided liner
> molded into the rubber that is real strong.  Using this hose with the clamps
> made for it sure would be easier than bending and forming steel lines.
> Anybody elso use this or have advice?  I can't see any disadvantages so
> far??
> 
> Mike Pilkenton