injector manifold design
Stowe, Ted-SEA
StowT at PerkinsCoie.com
Thu Mar 25 04:23:36 GMT 1999
sorry make that thanks Harold.
uh, duh.
-----Original Message-----
From: Stowe, Ted-SEA
Sent: Wednesday, March 24, 1999 8:19 PM
To: 'diy_efi at esl.eng.ohio-state.edu'
Subject: RE: injector manifold design
interesting, I like this idea.
I need to buy 2 injectors for this, are there any specific injectors that
have adjustable mounts or any that would lend themselves to this idea ?
thanks Howard.
-----Original Message-----
From: AL8001 at aol.com [mailto:AL8001 at aol.com]
Sent: Wednesday, March 24, 1999 5:47 PM
To: diy_efi at esl.eng.ohio-state.edu
Subject: Re: injector manifold design
On a engine with two valves per intake port and one inj per port, why not
aim the injector towards the cylinder that's lean? Might not be directly
towards the lean cyl, just slightly towards it. Make a 2 or 3 piece
adjustable
injector boss that will allow for the spray pattern to be adjusted left to
right and up and down.
The inj mounting would have bushing "A" drilled off center this would fit
inside Bushing "B", "B" would be drilled diagonal bushing "C" would be
welded to the intake. All bushings would have a O ring seal, set screw, and
some way to turn the bushing.
Another solution would be to have a o ring large enough to allow the inj to
swivel.
Harold
More information about the Diy_efi
mailing list