Electromotive CPS Pinout
Tom Parker
parkert at ihug.co.nz
Wed Nov 10 05:07:37 GMT 1999
Hi,
I've just bought an electromotive crank trigger wheel and sensor. The sensor
has 3 wires: a red one, a black one and a braided shield. I'm assuming that
the sensor is a normal hall effect device. This would mean there is a ground,
a power supply and a sensor output.
Now, I could guess that the red wire is the power, the braid is the ground and
the black is the signal, but I don't want to blow it up. Does anyone have a
pinout for this sensor or a schematic for a circuit to drive it?
Does it need any current limiting resistor in the power supply?
--
Tom Parker - parkert at ihug.co.nz
- http://www.geocities.com/MotorCity/Track/8381/
More information about the Diy_efi
mailing list