Electromotive CPS Pinout

[Jason Leone]

DIY_EFI Digest wrote:
> 
> Date: 10 Nov 99 18:00:33 +1200
> From: "Tom Parker" <parkert at ihug.co.nz>
> Subject: Electromotive CPS Pinout
> 
> Hi,
> 
> I've just bought an electromotive crank trigger wheel and sensor. The sensor
> has 3 wires: a red one, a black one and a braided shield. I'm assuming that
> the sensor is a normal hall effect device. This would mean there is a ground,
> a power supply and a sensor output.
> 
> Now, I could guess that the red wire is the power, the braid is the ground and
> the black is the signal, but I don't want to blow it up. Does anyone have a
> pinout for this sensor or a schematic for a circuit to drive it?
> 
> Does it need any current limiting resistor in the power supply?
> 

You should have a Black wire (this is the shield), a Green wire (this is
for the sensor ground), and a Red wire (this goes to the MAG PU signal
input on the TEC II). So, the Red should be the signal wire. 

Good luck.

Jason