newbie

[Shannen Durphey]

Hi.
Lots to learn, lots to do.
Here's a good place to start. 
http://www.diy-efi.org/gmecm/

How about a homemade efi intake?
http://xephic.dynip.com/dodge/dodge.html
Have fun!
Shannen

DarthOlds at aol.com wrote:
> 
> Hi,
> New to this list, and a GM owner.
> For the time being I'll just hang out and lurk. I just want to learn a little
> more before I open my big mouth.
> A little about me now.
> I'm a long time member of the Oldsgmail list (also on Majordummy).
> I'm an Olds man. I have an 83 Cutlass Supreme project car, and 84 Cutlass
> daily driver. I want to use a port FI setup on my Olds motor. I figure this
> is the best place to start.
> Here's the deal, I read an article in HotRod about a 55 Olds with TPI Olds
> 368.
> I want to do the same, only with my 307. I'm going to have a sheetmetal
> intake built,
> and have Lingenfelter install the injector bungs and fuel rails. I will use
> the throttle
> body, injectors, and ECU from a 305 TPI unit I salvaged from my wife's 85 TA.
> Well, that's the plan.
> Any ideas, comments, or anything I should know?
> Looking forward to learning a lot.
> 
> DarthOlds
> Kevin White
> http://members.xoom.com/dvaderolds/cutlass.html
> ----------------------------------------------------------------------------
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org