peak and hold injectors

[Anthony Buccellato]

Hey Walt,

Thanks for the info. I don't need 160 lbs/hr units, not sure how that
ended up in the thread. I calculate I currently need 76 lbs/hr with a high
BSFC, as I understand boosted applications sometimes exhibit. I would
prefer to get closer to 100 lbs/hr to allow some room for future
improvement.

Checking with the injector companies has shown me it's either Rochester or
Bosch Motorsport. Rochester is appealing, due to low cost, I've found them
for $62 for 82 lb units. I've heard Bosch is better, and some of their
units are even offered in stainless steel, big plus for us boaters.

I really want to avoid staged injection, at this point. Cost, complexity,
etc. High PW resolution should do me fine at an idle, I figure.

If you've got injector pattern pics, please send them. Any further insight
on Bosch vs. Rochester would be welcome, as well as suggestions for
reasonably priced suppliers, would be great. Thanks.

- Clay

Oh yeah, please comment on "Rochester isn't as precise"

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org