Injector drive circuit mods?

[nacelp]

Talk to the guys over at EFI332, they have boards for drivers,
Grumpy

> Dear all,
> I have a Weber ecu :W45.06/L20_67. It drives 4 2.5 Ohm injectors. I want
to
> add another four injectors. I am aware of the special chips by Cherry and
> Motorolla that can drive peak and hold injectors correctly but I do not
have
> the time to source them at this moment. The injectors are driven by BDX53M
> power darlingtons with some smaller transistors all controlled by some ICs
I
> cant recognize.(This might be not correct, I just figured it out looking
at
> the pcb.)
> I think I could possibly try  two options :
> 1)Install the secondary injectors(they are peak and hold too) in line with
> the primaries thus doubling the resistance and inductance seen by each
> output transitor. Probably would have to add inductive kickback
> protection.Could anyone guess how thta would change the range of the
> injectors?
> 2)Use another set of four same spec output transistors(BDX53M) to drive
the
> injectors. Connecting the bases of the additional transistors in parallel
> with the ones in the ecu. I have no idea how that would effect the driving
> IC and or the current regulation.
>
> I am mechanical engineering student so my understanding of electronics is
> basic.
> I would appreciate it if someone could help me out correcting my thoughts
or
> pointing out a different-better way.
> Thank you very much.
> John Andrianakis.
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org