Baud rate

[Al Lipper]

Good thinking, Daniel.  You may be right.  In the latest version, we are
trying 4800 baud and it seems to be working pretty well.  Perhaps give the
slower baud rate a try.

			Al


> -----Original Message-----
> From: Daniel [mailto:duagu at hotmail.com]
> Sent: Thursday, March 02, 2000 7:32 PM
> To: Al Lipper
> Subject: Baud rate
>
>
> Hi al,
> bear with me for a minute. i poked a bit around the fload.asm and was
> wondering if the 9600 baud rate could be causing the errors. I
> checked with
> the original hex loader and it was set at 2400. I also downloaded a baud
> rate calculator for a dallas equivalent of the 87C51. At 12mhz,
> they stated
> the error is about 7%. I'm not too sure what this means but at
> 2400, it was
> just 0.2%
> I'm not sure how to change the baud on the fload.asm. I think its from
> BaudLoad equ -39  ;9600 at 12MHz
> binary = 111001
> to
> BaudLoad equ -3b
> binary = 111011
> I'm also not sure about how it would affect the other timings in the
> program.
> could you advise on this?
> thanks a lot for your help.
> Daniel
>
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org