REALLY basic newbie ?'s

[Bruce Plecan]

Hey, Joe
Can I just pay you get and install an ecm (least in that URL that looks like
what you do)?.
Oh wait that really does stretch the DIY to just writting a check.
Hey, maybe a Penmanship 101 is in order
Bruce



> > Hello everyone, thanks for reading this.
> > I have a bunch of newbie questions related to wanting to reprogram a
> Nissan
> > ECU for boosted conditions. I'm not new to car mechanics, electronics,
or
> > computers, just "brains" & non-internet programming.
> >
> > 1. What hardware/software do I need to get to read/write the chip?
> > 2. Is there a "basics" page I can read through on ECU internals?
> > 3. Do all ECU's use the same or simular coding?
> > 4. What do I need to know about my paticular ECU before I ask more
> > questions?
>
> To now turbocharge an engine and sort out all the map point is time
> consuming and with little experience, lots of chance to destroy engine.
> Why not buy an Autronic system and enjoy immediate results for
surprisingly
> low cost.
> From the normally aspirated Nissan ECU you can never attain the same
> refinement.
> $1536Aus ....1 US dollar = almost 2 AUS dollar
> See some data at
> > www.beninca.com.au/autronic.htm
> > Joe>


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org