Ignition system for E6S-8

[Jörgen Karlsson]

> 	I have a 4 cylinder engine that I have swapped a Haltech E6S-8 to.
> I am in a bit of a bind for the ignition system however;  I would like to
> run a Direct Fire ignition with 2 waste spark coils.  The Haltech
> apparently
> cannot drive the coils directly and the manual suggests Bosch ignition
> drivers pt # 1 227 022 008.  I am assuming I would need two units, one to
> drive each coil.

First of all, I am pretty sure that you can drive up to four coils with the
E6S, but it only has two that is marked IGN1 and IGN2, the others have some
other marking. It should be a diagram for this on their site. If you still
want to run waste spark M&W has two channel ignitiors, I think that there
are some kind of cooperation between them and Haltech. All haltech dealers
seem to have their stuff, in sweden with lots of tax the dual ignitor are
US$100.

EMS in Australia, that I buy my stuff from has two channel ignitors for
US$40. Check with www.mdrace.com in Florida if you can't get anything
similar locally, they should have them. www.force-efi.com should also have
something similar, he might be a better choice as he works with Haltech. He
should be able to get you the coils too.

Jörgen


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org