Autronic Questions

[Bruce Plecan]

> > > I have been looking at:
http://www.turbofast.com.au/autronic/analyzer.html
> > > according to this, the Bosch 4-wire with the Model A analyzer is good
> from 10.0:1 - 36.0:1...
> > > the main thing it appears to lose over the NTK UEGO is sensor speed.
> This was the setup I was planning
> > > on using (Model A + Bosch) in conjunction with the Autotune feature...
> Checkout www.beninca.com.au/autronic.thm

> You must remember that position of sensor and engine speed afects the
> response time of ANY exhaust sensor

What?.
The sensor if half accurate, and not too heavily dampened should see the
latency of the ecms calculations.  ie momentarily lean as the AE correction
is applied.  If the sensor is cooled or what ever and that effects the
response O2 reading that's a problem with that paticular ecm, and not a
statement for all ecms/ WBs/
 Bruce
> If you have an Autronic system only a valve needs to be purchased to
> complete a closed loop boost control with RPM, temperature and throttle
> position and if SM2 then you have 3 boost curve that will automatically
> change with gear ratio or with a steering button for that OVERBOOST
> J Beninca

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org