Autronic Questions

[Joe Beninca]

----- Original Message -----
From: Bruce Plecan <nacelp at bright.net>
To: <diy_efi at diy-efi.org>
Sent: Wednesday, 1 November 2000 5:15 AM
Subject: Re: Autronic Questions


>
>
>
>
>
> > I have been looking at:
> > http://www.turbofast.com.au/autronic/analyzer.html
> > according to this, the Bosch 4-wire with the Model A analyzer is good
from
> > 10.0:1 - 36.0:1...
> > the main thing it appears to lose over the NTK UEGO is sensor speed.
This
> > was the setup I was planning
> > on using (Model A + Bosch) in conjunction with the Autotune feature...
>

Checkout www.beninca.com.au/autronic.thm

You must remember that position of sensor and engine speed afects the
response time of ANY exhaust sensor

If you have an Autronic system only a valve needs to be purchased to
complete a closed loop boost control with RPM, temperature and throttle
position and if SM2 then you have 3 boost curve that will automatically
change with gear ratio or with a steering button for that OVERBOOST

J Beninca

> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org