Autronic Questions

[Joe Beninca]

www.beninca.com.au
Joseph Beninca
B Mech E (Melb) AM SAE A
581 Canterbury Rd
Surrey Hills
Victoria 3127
----- Original Message -----
From: Jeff Bromberger <blownz at home.com>
To: <diy_efi at diy-efi.org>
Sent: Wednesday, 1 November 2000 4:54 AM
Subject: Re: Autronic Questions


> I have been looking at:
>
> http://www.turbofast.com.au/autronic/analyzer.html
>
> according to this, the Bosch 4-wire with the Model A analyzer is good from
> 10.0:1 - 36.0:1...
>
> the main thing it appears to lose over the NTK UEGO is sensor speed. This
> was the setup I was planning
> on using (Model A + Bosch) in conjunction with the Autotune feature...
>
> >Yes the speed

> After buying Autronic you only need the $175 Aus valve.
If you have 2 big waste gates eg 1,3/4 inch garret then you need a valve of
larger air flow
 $250Aus

Thankyou
J Beninca
-----------------------------------------------------------------
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org